Soundoff-signal 400 Series Remote Amp Box Manual do Utilizador descarregar pdf

Operating Modes

The primary operating modes are User

Selectable tone, Yelp, Wail, Radio, PA,

Horn Override, and a push-button Manual

Override are available in all modes. All

tones except Wail and Yelp for California

Title 13 compliance may be disabled by

programming the siren.

-Microphone Bracket Installation-

A metal clip is provided for mounting the microphone. Choose a

location convenient to the operator and away from any air bag deploy-

ment areas. Using the mounting clip as a template, mark the two

holes to be drilled. Using a 1/8” drill bit, drill the two mounting holes.

Install the two #6 screws provided with the bracket.

WIRING:

WARNING! All customer supplied wires connecting to the

positive terminal of the battery must be sized to supply at least

125% of the maximum operating current and FUSED at the

battery to carry that load.

Ensure the siren ampliﬁer / relay unit is mounted in dry, protected

environment.

TECHNICAL SPECIFICATIONS

Overall Dimensions:

Control Panel:

Ampliﬁer/Relay:

3.51” W x 6.89”H x 1.17”D

2.62”H x 7.00”W x 6.51”D

Input Voltage: 10 - 16Vdc (negative ground)

Boxed Weight:

8 lbs.

Operating

Temperature:

-40°C to +50°C

Diagnostic LEDs: Speaker shorted/open, internal fuses open,

communications faults

Siren

Input Current 7 Amps @ 13.4 VDC (100W Speaker)

14 Amps @ 13.4 VDC (2 x 100W speakers)

Standby Current:

Ignition ON:

Ignition OFF:

500mA

<10mA

Output Power

ETSA481: 1x100W RMS Max (11 Ohm speaker)

ETSA482: 2x100W RMS Max (11 Ohm speaker)

Audio Frequency: 500-3 kHz

Siren Frequency: 675Hz - 1633Hz

High Voltage

Protection:

Limits to <18V*

*If siren tone is in progress, sound will continue

during overvoltage. New siren tone will not

activate if voltage is >18V

Low Voltage

Shutdown::

Voltage<9.0V will cause siren output to cease

and will resume when system voltage is >9.5V

Tone disable for California Title 13 compliance

Auxiliary Input connection for remote manual or Hands

Free operation

Speaker Protection: Shorted, Open: Stop output signal, preserve Amp

Light Control

AUX button relays: 9 total 10A max each circuit

Total current not to exceed 50A for CN8 pin 5

2 of the 9 available for external Arrow control

2 of the 9 have their source voltage switchable

from internal to external via fuse location, see

pg 5

Slide Switch Relays: 3 total 20A max each circuit,

Total current not to exceed 50A for CN8 pin 4

WARNING

Do not install this product or route its wires in

the air bag deployment area.

Doing so may cause damage to or reduce

effectiveness of the air bag, or create projectile

that could cause serious injury or death.

To determine air bag deployment area refer to

vehicle manufacturer's manual.

MOUNTING

-Ampliﬁer Installation-

Before drilling holes, check for clearance to prevent

damage. Check both sides of the mounting surface

before drilling and the be aware of any vehicle

components or other vital parts that may be damaged

during drilling.

Install grommets in any wire passage holes.

1. Slide ¼” hex head bolts into siren ampliﬁer t-slots.

2. Place mounting brackets over bolts.

3. Thread ¼” lock nuts onto bolts and tighten down.

4. Use mounting bracket holes to secure ampliﬁer

5. Install ampliﬁer with clearance from other objects

for improved ventilation.

400 SERIES AMPLIFIER BOX

PSRN4ANR1

PSRN4ANR2

1.800.338.7337 / www.soundoffsignal.com

ETSA48(x)RSP 3.4.13

1 2 3 4 5 6 7

Resumo do Conteúdo

Página 1

Operating ModesThe primary operating modes are User Selectable tone, Yelp, Wail, Radio, PA, Horn Override, and a push-button Manual Override are avail

Página 2 - 400 SERIES AMPLIFIER BOX

RADIOREBROADCASTNEUTRAL SAFETY SWITCHIGNITION3 ampFuseYELLOW BLUEBLUEORANGE/BLACKHorn Ring OutHorn Ring InAuxiliaryVIOLETBacklightGRAY RADIO REBROADCA

Página 3

To Device requiring power only when Ignition Switch is onFrom Siren Switch Output+V when Ignition Switch is ONNORMALLY OPEN CONTACT RELAY1 Amp11223550

Página 4 - REMOTE CONTROL PANEL

REMOTE CONTROL PANELPSRNCTRL1, PSRN4CTRL1PROGRAMMING MANUALNOTE:For All programming modes: Momentarily depress Radio Rebroadcast push-button to exit.

Página 5

2. Buzzer: Audible tone from control panel whenever operator presses push-button or changes position of slide/rotary switchON = Buzzer enabledOFF =

Página 6

PROGRAMMING MODESAUXILIARY SWITCH SETTINGS:Refer to Figure at bottom center for Button and LED locations and terminology1. Press and Hold Auxiliary Bu

Página 7

BUTTON #6BUTTON #7BUTTON #8SPKR A SPKR BOFF OFF OFF WAIL 1 WAIL 1OFF OFF ON WAIL 2 WAIL 2OFF ON OFF WAIL 1 WAIL 2OFF ON ON WAIL 1 YELP 1ON OFF OFF WAI

Comentários a estes Manuais

Sem comentários

Soundoff-signal 400 Series Remote Amp Box Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Acessórios de comunicações Soundoff-signal 400 Series Remote Amp Box. SoundOff Signal 400 Series Remote Amp Box User Manual Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais

Manuais e produtos relacionados com Acessórios de comunicações Soundoff-signal 400 Series Remote Amp Box